For the construction of gardens and landscaping, many open spaces and related projects require a large amount of weathering steel as support. In the case of reconstruction, it is necessary to laser cut the weathering steel plate to obtain a better practical effect. Since the weathering steel plate has strong utilization performance and strong correlation, it takes time and effort to thin it. Therefore, today, we have conducted a scientific research on some precautions for cutting weathering steel step by step.
First, for projects that require high cutting precision of weather-resistant steel plates, in the case of edge punching production and processing, the measured cutting length should be added to the half warp of molybdenum wire. Due to the high requirements on precision, although the molybdenum wire is very thin, in order to improve the precision and product quality, this deviation cannot be ignored.
Second, it can prevent the molybdenum wire from breaking when cutting. The second is to check the water storage tank of the equipment every two days to check the condition of the cutting fluid.
Third, regularly maintain the conductive block. If the groove marks are too deep, they must be replaced. Because the groove is too deep, the cutting line will break. If the cutting wear-resistant steel becomes spiral, it must be replaced immediately, otherwise it will affect the quality of cutting products.
Fourth, when cutting large and medium-sized product workpieces, it must be checked whether the length of the CNC lathe is sufficient to cut the product workpiece. self-calculation. When the product workpiece touches one side, the product workpiece is eliminated, and the vibration result on the other side is divided by 2.
Fifth, cutting aluminum. If the aluminum content is relatively small, shorter conductive blocks must be prepared in advance. During the production process, because the alumina on the molybdenum wire has been cleaned, brush some gasoline on the molybdenum wire within half an hour. Other ingredients can also be used to remove aluminum oxide from the surface. When cutting aluminum, molybdenum wire can be twisted into a ball, which is then flattened and placed on a guide block. The application is very convenient and the cost is very low.
To sum up, the above are the main contents of the precautions for cutting weather-resistant steel plates.